Trunk Spoiler Compatible with 2003-2008 Toyota Corolla All Factory Style Lip Primer - UNpainted

- Color: None - Primer Only - Third Brake Light: Not Equipped - Material: Blow Molded ABS - Installation: Drilling Required - Mounting hardware included. - Installation Instructions: Included

Product description

Vehicle specific primered trunk spoiler - Primered with no color.

Drilling required to install - Stainless / brass mounting hardware included.

Drilling locator strip - How tos

No color - Primered

Please note: This spoiler comes primered only and must be painted by the customer’s body shop before installation. It is not color?matched from the factory. Painting ensures a perfect finish that matches your vehicle’s exact color and quality standards.

Precision Style Made Simple.

Give your vehicle a clean, factory?fresh edge with our OE?style trunk spoiler, enjoy a perfect fit that looks like it rolled straight off the showroom floor. Delivered primered and ready for paint. This spoiler requires drilling holes into the vehicle’s trunk for proper alignment and secure mounting. Professional installation is strongly recommended to ensure accurate placement, a clean finish, and long?term durability.

Spoiler is Not equipped with brake light.

Spoiler include stainless / brass hardware, pre-applied foam gasket and automotive grade double sided tape. Clean bonding area with rubbing alcohol to ensure complete bonding.

Drilling is required to install. Drilling locator strip included. General instructions included.

Note: Spoiler will Not lineup with any existing holes drilled for factory spoilers .

Installation should be done when temperature is above 70F for optimal adhesion. If needed, carefully warm up both the spoiler and the trunk area with a hair dryer using low heat.

Precision ABS blow molded constructions ensure consistence fitment, excellent durability against element and weather.

Remove vehicle trunk / hatch interior down to bare metal. inspect thoroughly to avoid damaging existing wiring / lock mechanism / hardware .

Locator strips are to be applied to the bottom of spoiler threaded holes, peel back adhesive backing at the center of the drilling strip, line up and stick drilling strip to spoiler.

Carefully position spoiler on trunk, then secure drilling strips to trunk using masking tape. Lift up spoiler leaving drilling strip in place to locate where the holes should be drilled.

Complete drilling using suggested drill bit sizing printed on the supplied instructions.

Do NOT over tighten hardware.